A recurve bow is the most efficient and effective bows. It is characterised by limbs that usually curve away from the archer when not strung. It has the excellent ability to store more energy and delivers more efficiently than a straight one. In additon, it releases the arrow at high speed. However, using a recurve bow is not a walk in the park. You need to be well versed with the procedure. We present you with basic steps on how to use a recurve bow so that you can apply.
Buy a bow stringer
You should consider buying a bow stringer because it helps to prevent damaging your limbs. Select one that is specially designed for a recurve type. It should also match the length of your bow as well as the draw height.
Put the cord over the tips of the recurve bow
This is done by sliding the string’s big loop over the top limb of the bow.Ensure that you position the cord on the right part of the bow. Insert the smaller loop into a groove situated at the lower limb. Check to ensure that it fits properly. The thread should have enough slack when the bow is in a relaxed position.
Fit the stringer patch over the top of the lower limb
If the wire you are using has two pockets, the bigger patch fits over the arm on the lower side. It is necessary that it covers the little string curve thus keeping it more secure in the groove. In the event that you feel this is not secure, you are recommended to wrap a rubber band around the curve of the string tightly.
Put the saddle/ smaller pocket onto the higher limb
Place the smaller pocket over the tip of the limb situated above in case your wire has two pockets. In the event that it has a seat on one side, you should glide it over the top arm as well as below string’s curve.
Hold the bow in horizontal position
Hold the bow horizontally using your non-dorminant hand. Ensure that your dorminant hand is closer to the limb on upper side while holding loose string fold in the right position. Hold the bow in a such a way that its arm tips face up while the instrument for stringing and bowstring face downwards.
Step on the bow stringer
Bend the bow at the waist position to lower it until the stringing equipment is in contact with the ground surface. Step on it with your two feet, some distance apart. Make sure that you step using the balls of your feet and not arches. This helps to prevent the cord from slipping.
Confirm the recurve bow
Confirm that you have a secure grip.
Slide the loop
Slide the curve of the loose string until it fits into the notch closer to the bow tip.
Lower the bow
Lower the recurve bow in a slow motion until the equipment for stringing becomes slack.
Check the string
Double-check to confirm that the wire is secure. In the event that it is not secure, you are advised to step on it once more.
Once you have confirmed that everything is secure, pull the recurve bow from behind with your fingers holding the arrow and shoot at your target.
In conclusion, this is the basic precedure on how to use a recurve type of bow. It is easy to understand and simple to apply.
To know more about recurve bows, visit our Best Recurve Bow Reviews.